This is a discussion on HELP! Warn winch install- need to install tonight within the Grizzly Electrical & Lighting forums, part of the Grizzly Forums category; Could someone help me with the wiring on my 2011 700 eps grizz? The warn instructions say to install the power sub-harness that was supplied ...
Could someone help me with the wiring on my 2011 700 eps grizz? The warn instructions say to install the power sub-harness that was supplied withthe atv, looks like its under the battery cover. The connector I see is not the same as the picture in the warn directions. This is to power the switch to contactor box. where do you get power if you need key on power???
O PLEASE HELP!!!!
I used the wire coming from the d/c plug outlet on the side of the bike. There are two wires, if I remember right, a brown and a green wire. The green wire is hot when you have the key in the on position.
__________________ 2013 Tac Black SE Grizzly 734
28" Zillas on 14" ITP SS212
Elka Stage 3 Front/Rear
Coop 2&3/Purple spring/14g greased greaseless
Wet Clutch Slugs
EHS Racing Mega 3/Barkers Duals
EHS Stage 1: 105.5mm 12.5-1 EHS HC Piston, Custom EHS Grind Cam, +2 Ferrea valves/Kibble white, 3mm overboar TB
RDC Low Profile Rad
Sounds like you got it under control (just in time for the weekend). Glad to hear that you got it all hooked up. Have fun riding and if you get stuck you have a winch that now operates.
__________________ 2011 Yamaha Grizzly 550 EPS / FI Green
Warn XT25 Synthetic Rope
Garmin eTrex Legend CX GPS
RAM Mount (for GPS)
Sway Bar Removed
1.5mm Shims (3:1 from 2.5:1 Ratio)
Symtec Heat Grip Dual Zone
6 gang fuse terminal
4 switches for add't accessories
2R Power Tip
Rock Sliders (Home Made)
Rev. Limiter Overide
Left Hand Throttle Control
My Garage http://www.grizzlycentral.com/forum/..._view&id=22557