This is a discussion on Starter hangs up? within the Grizzly Engine & Transmission forums, part of the Grizzly Forums category; Hi everyone,
Have a Grizzly 600 4x4. When I hit the start switch it sounds like the starter stays engauged for a bit then releases. ...
Have a Grizzly 600 4x4. When I hit the start switch it sounds like the starter stays engauged for a bit then releases. It does start just fine but with this hangup. I would think it would be the starter not the sylinoid. Any ideas?
im not sure but i just bought a starter i will install it today i had the same problem and the other day i went to start the bike and the starter stayed engaged the bike did not start and drained the battery im not sure if it is the solinoid or starter i cant find a replacement solinoid
Does it sound like the starter is staying energized after you release the button or that it just stays engaged and delays coming off. If it stays energized, it could be your contactor sticking or even your button. You may need to take them apart and clean them. If it is hanging up, take it off, clean it and make sure the gear and stem move freely, if needed, as a little grease.
2016 Grizzly 700 Special Edition W/EPS - Carbon Metallic
27in Kenda Bearclaw HTR
Ricochet Full Skid Plates w/UMHV
Viper Elite 3000lb Winch w/Amsteel Blue
Totron 12in & 6in LED Light Bars
Yamaha Rear Cargo Box
PowerMadd Guards & Wraps
RotoPax 4 gal Fuel Pack
2009 Rhino 700 Special Edition - Black
27in Sedona Rip Saw on ITP Black SS108 Wheels
Viper Max 4000 w/Amsteel Blue
Ricochet Full Skid Plates, K&N Filter, EZ Steer Power Steering
Totron 12in LED Light Bar & 4 - 3in Cubes
J Strong Roof & Windshield
J Strong Front & Rear Bumpers
J Strong Dual Battery Isolator
2002 Grizzly 660 - SOLD
US Govt survey shows three out of four people make up 75% of the total population.
The Following User Says Thank You to UpstateNYGrizz For This Useful Post: