This is a discussion on 660 Clutch bearing housing removal "4 legged cage" within the Grizzly Talk forums, part of the Grizzly Forums category; I'm trying to do the shim mod on my grizzly 660. I have done this on 3 King Quads and 3 Rhinos. But I'm having ...
I'm trying to do the shim mod on my grizzly 660. I have done this on 3 King Quads and 3 Rhinos. But I'm having a bit of trouble removing the bearing housing that has the 4 legs and bolts. I have had to wack them before with a hammer to get them to come loose. After the bolts were removed of course. I have removed all 4 bolts. But the 4 legged bearing housing will not jar loose. I have hit it with a hammer from all 4 angles. But nothing... Scared I'm gona break something. What's the deal? Something I am missing? Hit it harder?
nope,if you removed the bolts it should come off. the last time i took mine off it came off hard too. just keep trying
2008 grizzly 700
26" bighorn OG's on ss212 black wheels
rigid industries 10" sr series driving light
ehs big 3 with uni air filter
jbs sheave,18gram weights,purple secondary
500 rpm stall springs
perfex skid plate
heat demon heated grips and thumb
rear pass. seat
If you can use a rubber mallet you'll minimize the chances of busting it. Plus, remember that it's holding the shaft in there, so you don't want to bang it around too much. I made a bent bar to hammer on. Looked like this:
RED 2002 Grizzly 660, 28" Gorilla Silverbacks, Wiseco 11:1 Piston, HotCams Stage 1 Raptor Cam, Raptor Valve Springs, DizGrizz Serious Air Filter Mod HERE, K&N Air Filter, Custom Rad Relocate, 1mm Shim, 660 Mega-Air Snorkels HERE,Powermadd Handguards, ODI Rogue Grips.