This is a discussion on grizzly 700 fuel tank mod need advice within the Grizzly Tech Tips forums, part of the Grizzly Forums category; Somone on the trail showed me his grizz 700 he removed the white ring inside the gas tank he said it creates a big air ...
Somone on the trail showed me his grizz 700 he removed the white ring inside the gas tank he said it creates a big air bubble. .He told me i would get app half a gallon more gas. HE told me to take a screw driver and needle nose to get out. He says thats the first thing he does when he gets a bike. I did see that gone from his bike . MY question is what is that peice? the factory must put them there for a reason .This guys bike ran great should i do it to my grizz? Hopefully we are on to a nice easy mod here for cheap . please help. thanks guys
Id say that is there to create an air lock so that u can't fill the tank too much. As when the gas expands it needs somewhere to go. So I wouldn't pull it out.
2010 700 LE Grizzly
28x12x12 SilverBacks on all four corners for mud play.
25.5 Growlers For General Play
2" RDC Lift
Full Ricochet Skids
Rox Hand Guards
Amsteel Blue winch rope (in red)
Mikes #2 and #3 clutch mod
4" HID driving lights
RAM mounts for GPS and Cameras
I'd suspect its there to allow for some fuel expansion, or to allow an air pocket to compensate for vapour pressures inside the tank.
If you took it out you'd never want to fill the tank right to the top anyway, or it would be spitting out anyway.
So not much to gain. Yamaha doesn't usually get in the habit of putting extra parts on the quad for no reason.
Today, 12:23 PM It's a safety feature and should be left as is from the factory. You don't want gas spilling out onto a hot engine or exhaust.
x2 it's there so that you won't over fill your tank (A Safety Feature), your suppose to stop when the gas reaches the lower rim.
__________________ 2011 Yamaha Grizzly 550 EPS / FI Green
Warn XT25 Synthetic Rope
Garmin eTrex Legend CX GPS
RAM Mount (for GPS)
Sway Bar Removed
1.5mm Shims (3:1 from 2.5:1 Ratio)
Symtec Heat Grip Dual Zone
6 gang fuse terminal
4 switches for add't accessories
2R Power Tip
Rock Sliders (Home Made)
Rev. Limiter Overide
Left Hand Throttle Control
My Garage http://www.grizzlycentral.com/forum/..._view&id=22557
When it comes to safety, modding a safety device out of the quad, riding double or not wearing a helmet etc., I don't care who's done it and for how long... just because someone else has been lucky doesn't mean I'm going to be.
I can't tell you how many times I've heard someone say "if only I had...(fill in the blank) when in the emergency room. Some arrived and weren't able to say anything!
Besides that, "Murphy" get's everywhere I'm going ahead of me and is always there waiting!
*·-:¦:-·* Silver 2011 Yamaha Grizzly 700 FI/EPS Special Edition *·-:¦:-·* Diablo Beadlocks with Pit Bull Growlers
Warn XT-30 Winch with Remote OGIO Front & Rear Rack Bags Moose Front & Rear Bumpers Ricochet Full Skid Plates Garmin GPSMAP 62st Maier Hand Guards
2" Receiver ODI Grips Rigid D2's
Well, after looking at my 660, once removed you would be hard pressed to get more than an extra cup of fuel in the tank. I personally don't see enough gain to remove the tanks ability to deal with fuel expansion.
I am leaving mine alone.
__________________ 2006 660 Grizz GGOC Agent #4
Way too many mods and repairs, accessories to list...
GrizzlyCentral.com is not associated with Yamaha in any way. We are an enthusiast site dedicated to the Yamaha Grizzly ATV. Our goal is to offer a place for Grizzly owners to discuss rides, events, mods, maintenance, purchasing, etc and offer help and assistance.Contact Us -
Yamaha Grizzly ATV Forum -
Privacy Statement -