Yamaha Grizzly ATV Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Grizzly Chassis & Body
    I'm restoring my 02 660. I was replacing my bearings fine until last knuckle/hub. One of the rear bearings is seized into hub. We've damaged the hub trying to press and hammer it out. Upon looking for replacing it I've found out the 02 is a one of a kind year. I can't find a replacement...
  2. Grizzly Talk
    Is this the typical axle popping out issue that everyone says is common with the 2003 Grizzly 660s? Can it be fixed with the Gorilla Square clips? Should the seal be replaced too? What else should I be looking for when I take this apart?
  3. Grizzly Engine & Transmission
    Hello everyone, hope you're doing well Recently after riding I noticed something wasn't right at the rear end of my Grizzly. On hard surfaces when turning I heard a grinding, clicking noise. Normally I ride on unpaved roads so I didn't notice for how longs this has been going on. The noise...
  4. Grizzly Talk
    Hey yall, I'm having an issue lining up a new rear left axle into a knuckle on my 03 Yamaha Grizzly 660. I cannot push in both knuckle bolts that go through the lower and upper control arms. The new axle was bought on Amazon...
1-4 of 4 Results