When you remove the yoke retaining nut, have you pulled the yoke off before trying to remove the bearing carrier? If not, that is your trouble. The splines for that yoke cam sometimes get rusty and make getting that yoke off difficult.
1998 Grizzly Rear Drive Shaft Bearing Housing
Im lost
Im trying to remove the bearing housing coming out of the back of the motor where driveshaft oil seal is
I took the 4 bolts out but i cant get it to budge ive broken most of the outside off where the boot is clamped onto it trying to get it out
Ive tryed heating it pb blaster everything
Am i missing a bolt after i remove the 4 and take the big nut in the middle out
Any tricks to getting these out
Thanks
Im trying to remove the bearing housing coming out of the back of the motor where driveshaft oil seal is
I took the 4 bolts out but i cant get it to budge ive broken most of the outside off where the boot is clamped onto it trying to get it out
Ive tryed heating it pb blaster everything
Am i missing a bolt after i remove the 4 and take the big nut in the middle out
Any tricks to getting these out
Thanks
1 - 4 of 4 Posts
1 - 4 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Yamaha Grizzly ATV Forum
A forum community dedicated to Yamaha Grizzly owners and enthusiasts. Come join the discussion about modifications, winches, batteries, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
Ridgway81432
66 Replies
reogem
38 Replies
01 Grizzly
26 Replies
Recommended Communities
