Yamaha Grizzly ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1 (Edited)
I had to pull my rear differential off to have it repaired and its been awhile since I had the axles off. I unbolted the knuckles from the A-arms because it was faster and easier to pull the axle.
My question is, I can't remember which way the knuckles go back on? I don't want to put them back on upside down....

Any quick tips or info on making sure I install them right side up would be greatly appreciated.

Thanks!
 

·
Registered
Joined
·
105 Posts
U got a pic? Clean them up good cause there should b markings on them. Short side up and grease nipples out. As long as an 02 is like an 03
 

·
Premium Member
Joined
·
1,693 Posts
Both the 2002 and 03 have the same part number for the rear knuckle, 2530F. Either way will work as long as they are both installed the same. There are many members here that have flipped the knuckles on 660's to gain ground clearance, maybe they will have something additional before you throw it back together.
 

·
Premium Member
Joined
·
7,801 Posts
The long end of the knuckle goes down and the short side up with the zerks facing out
 

·
Premium Member
Joined
·
10,180 Posts
1 - 6 of 6 Posts
Top