Hey everyone, I’ve been working on a 07 grizzly 350 and and I just it to start by replacing the starter relay solenoid. It’s an automatic and when I put it in forward and drive and the stop it’ll idle for a few seconds and the stall out. Any ideas on how to fix this or what it may be?
2007 Yamaha Grizzly 350
1 - 2 of 2 Posts
Joined
·
11,695 Posts
Welcome from Colorado.
I would start with a full tune-up, including valve check/adjustment. It runs so its not far out of adjustment, but these are low compression engine and very sensitive to small problems.
I would also adjust the a/f screw, 2.5 turns from bottomed out in the carb and adjust the idle down as low as it will go with the engine still running. This will keep the wet-clutch from engaging for easy shifting, ten service the c.v.t. and count the ratio to predict internal problems.
While you have the tank off, drain and clean and refill with fresh gas.
I would start with a full tune-up, including valve check/adjustment. It runs so its not far out of adjustment, but these are low compression engine and very sensitive to small problems.
I would also adjust the a/f screw, 2.5 turns from bottomed out in the carb and adjust the idle down as low as it will go with the engine still running. This will keep the wet-clutch from engaging for easy shifting, ten service the c.v.t. and count the ratio to predict internal problems.
While you have the tank off, drain and clean and refill with fresh gas.
1 - 2 of 2 Posts
Join the discussion
Join now to ask and comment!