Yamaha Grizzly ATV Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter #1
Anyone have 30" Zillas on there latest gen Grizzly? Any need for clutching or fender cutting?
 

·
Registered
Joined
·
566 Posts
Gonna need clutching for sure. Not sure if they fit or not. I know when I had my 'gade, 26s looked close but had room to go more. I put on a set of 29.5 outlaws and they fit and didn't rub. I have 26s on the grizz, and there is more room there than was on the 'gade.
 

·
Registered
Joined
·
4 Posts
just installed 29.5 super atv terminators on my 2017
but i have a 2 inch lift kit and 1.7mm shims and dalton red metallic spring
 

Attachments

·
Registered
Joined
·
252 Posts
30x11 on my 17. I added a 2" lift because I have my daughter with me the majority of the time when I'm riding. 2.0 shim, kodiak weights, and gold secondary spring. The way they should come from the factory!....Lol (no fender cutting, even before the lift with just me on it though. Rubbed a very small amount right in front of the rear tire in the flared foot well area)
 

·
Premium Member
Joined
·
9,851 Posts
30 rubber on 14 disks, becomes normal, does not touch. the variator is threaded and a washer 0.6 mm is installed.
Welcome from Colorado.
Think about starting a new thread, I'm wondering what a threaded variator is all about.
 

·
Premium Member
Joined
·
9,851 Posts
Variator is your reference to the movable sheaves, was making sure.
 
1 - 9 of 9 Posts
Top