Yamaha Grizzly ATV Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
138 Posts
Discussion Starter #1
Stripping the quad down to replace wheel bearings, which all four are shot, and I came to this. The left rear axle is stuck in the hub. It looks like the spline teeth are not seated properly, and this may be my problem. Another problem may be my wheel bearing may be holding the axle, possible? Would it be wise to press the axle out of the hub, or am I asking for trouble?
 

·
Premium Member
Joined
·
9,276 Posts
You could have two different problems going on.
Stripped splines in the hub? can you tap the hub right or left to align the hub with the axle splines?
Not sure which machine you are working on to know the bearing set-up.
 
1 - 4 of 4 Posts
Top