Yamaha Grizzly ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
295 Posts
Discussion Starter #1
Does a person need to clean or wash a cvt belt if your reusing it? The belt has not lost enough according to the specs to replace.
 

·
Premium Member
Joined
·
9,286 Posts
I don't, but mine hasn't been covered in grease. I put it on going in the same direction as it came off.
 

·
Premium Member
Joined
·
3,069 Posts
If the belt is clean just install it, I would scuff the sheave faces with a scotch brite pad and then clean the faces with brake cleaner before replacing the belt. I'm not sure why you had the belt off, was it for maintenance or just to check the belt?
 

·
Registered
Joined
·
1,214 Posts
If it's covered in grease scrub it in hot soapy water. Takes a lot of scrubbing though.
 

·
Registered
Joined
·
295 Posts
Discussion Starter #6
I took it off to put a Jbs sheave on and wet clutch weights.
 
1 - 6 of 6 Posts
Top