Clutch Housing bearing removal

1897 Views 2 Replies 3 Participants Last post by Vincent, Sep 22, 2017

KArthur

Discussion Starter · Sep 22, 2017

On my 98-600, I am trying to figure out how to remove the small bearing that is in my clutch housing. The bearing is item #7 below. I have removed the snap ring (item 8), but it looks like the bearing has to go out the other way. The od race is too large to come out the way the snap ring comes out.

I didnt see a way to remove the shaft on the end of the housing.

Ideas?

See less See more

Save

1 - 3 of 3 Posts

waltinbatonrouge

· #2 · Sep 22, 2017

---

Save

Vincent

· #3 · Sep 22, 2017 (Edited)

I don't have any experience on this specific bearing situation, but it mite be worth getting local garage that you trust to remove it for you. They have all the specialty tool that most of us don't, and they mite get it done in minutes. I've done this a few times on various other projects and the garage never even charged me a dime. Worth a shot.

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month