Yamaha Grizzly ATV Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
Hi everyone I’m replacing the 1 way bearing now. I’ve stripped the primary down to check it and there is little if any grease inside. This is my first grizzly I’m just wanting to know if this is a greaseless set up or there just isn’t any in there and needs repacking. If someone could check the picture out and let me know. Thanks
 

Attachments

·
Registered
Joined
·
1,393 Posts
Those are stock weights thus require grease.

Hope your using the proper Yamaha one way....
 

·
Premium Member
Joined
·
9,006 Posts
There is grease in the channels, at the outer edge from being slung out due to centrifugal force.
After cleaning my movable sheave I use @ a teaspoon of grease in each channel.
I've read that Yamaha added grease to reduce noise, not reduce wear. I ran a set of stock weights without grease for a while without damage.
I didn't see flat spots on your weights.
 
1 - 4 of 4 Posts
Top