Yamaha Grizzly ATV Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
275 Posts
Discussion Starter #1
Finally went and installed my Superwinch LT3000 and guess what?

It would let out cable but not reel it back in.

Lucky for me that the farm store I bought it at could look up my purchase and was nice enough to exchange it, although it had been months since I'd bought it.

The install went much faster the 2nd time:banana:
And it worked too! The solenoid was bad on the 1st one.
 

·
Registered
Joined
·
275 Posts
Discussion Starter #8

·
Registered
Joined
·
275 Posts
Discussion Starter #10 (Edited)
Pic? I want to see one installed!
Hey, I didn't think about it until now, but here's a couple of pics for install.

One pic is where we placed the remote connection and the other is the mounting of the switch to the brake fluid reservoir clamp.
 

Attachments

·
Registered
Joined
·
230 Posts
I put the switch on the bottom bolt without the extender just in case of another roll over that way it don't get destroyed again. It will be upside down but no big deal. I learned the hard way...lol
 

·
Registered
Joined
·
21 Posts
Or go to wallie-market, and buy a rubber roller for a boat trailer (for ~$5 I think). Cut it in half and feed your line through it.


dw
 

·
Registered
Joined
·
275 Posts
Discussion Starter #14
I have a rubber stopper 2 pack coming from amazon for $10. Going to give one to my buddy.
 
1 - 14 of 14 Posts
Top