Yamaha Grizzly ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Hello all. My name is Ken and I am new to the forum and to the 4 wheeler community. I am a retired Marine. I just purchased a 2004 Grizzly 660 and am looking forward to using it. Any insight on working with it would be greatly appreciated.
I noticed the warn winch on it will go out, but not back in. I assume that is a solenoid issue, but have not dug into it yet.
Semper Fi
Mongo
 

·
Premium Member
Joined
·
10,629 Posts
Welcome from Colorado.
The switch on the bars may have a wire problem, or the contact switch may be bad.
I would change the power supply wire positions on the winch to see if it runs the other way, to eliminate the winch. If the winch works, change other wires back to the handle bar switch until you find the problem.
You might find a wire not connected.
 

·
Premium Member
Joined
·
3,764 Posts
Welcome aboard Ken and Semper Fi! :gcrules:
 

·
Grizzled
2014 Yamaha Grizzly 700 EPS
Joined
·
3,661 Posts
Welcome to GC!
 

·
Registered
Joined
·
867 Posts
Welcome from Missouri and thank you for your service!!!!!
 
1 - 6 of 6 Posts
Top