Yamaha Grizzly ATV Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi. I'm replacing the bearing in the primary clutch housing, and the new bearing is a sealed bearing on both sides, but the old bearing is only sealed on one side. My question is, should I remove the seal on one side of the new bearing or just leave it with both sides sealed before installing? Thanks.
 

Attachments

·
Registered
Joined
·
380 Posts
I'd leave both sides sealed.


Sent from my iPhone using Tapatalk
 
  • Like
Reactions: reogem

·
Registered
Joined
·
5,540 Posts
Leave it sealed.
 
  • Like
Reactions: reogem

·
Just wanna ride!!
Joined
·
5,517 Posts
Agreed. Install it as it arrived.
 
1 - 5 of 5 Posts
Top