Yamaha Grizzly ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter #1
Recently my brother was riding my grizzly 660 (w/o permission of course) and he snapped an axle while pulling wheelies. My getting tired of snapped axles, this thing is stock with 25 inch tires and constatntly breaks them. We have a trx700xx with cv axles and it has never snapped one, its way lighter and has much thicker axles from the factory. I have donw the niche axle, knuckle, and hub swap up front, but what do I need to do it in the back? I'm guessing I need all three things, right? The bike is 2002 thats why im swapping. 2002 axles are a rip off, cheapest one was $92 on ebay while niche 25% thicker ones are just $60.

Sent from my SM-N900V using Tapatalk
 

·
Registered
Joined
·
5,546 Posts
You need the same for the rear. Knuckle, hub and axle....and you'll be good to go.
Install the newer axles and ride on.

Btw, I run 30" tires and have the Niche axles all around. Been running them for almost 5 years now. I have never broke a Niche axle.
 

·
Registered
Joined
·
88 Posts
Discussion Starter #3
Ok i will be on the look for a deal of used knuckles on ebay

Sent from my SM-N900V using Tapatalk
 
1 - 3 of 3 Posts
Top