Yamaha Grizzly ATV Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi everyone I got a 2000 grizzly 400 just replaced carb and starter was starting fine when I replaced starter and when I replaced carb decided to strip the bike down and give it a good clean put new carb on and hooked up new battery before putting it back together but now I don't get any oil light or neutral light when key is on and the fan comes on as soon as I hooked up the battery with the key turned off..please help
 

·
Registered
Joined
·
175 Posts
Sounds like you have a short with either getting water into something it a bad or crossed wire. seems like some wire tracing is in order.
 

·
Registered
Joined
·
175 Posts
Have traced wires and used test light and still no luck any other ideas plz
Wish I could help more, but after reading your post. it still seems to me that some wires are crossed somewhere. like a ground and hot is mixed up.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #5
Is the starter motor lug on the the solenoid meant to be a ground.....cause mine is
 
1 - 5 of 5 Posts
Top