Yamaha Grizzly ATV Forum banner

No spark I'm losing my mind!

603 Views 3 Replies 3 Participants Last post by  amartyn929
I'm working on a 2000 grizzly 600 I've gotten a new cdi stater coil spark plug and striped the wire case complete looking for broken wires and I have no idea why I don't have any spark. Does anyone have any suggestions? Thanks.

Sent from my SM-G530W using Tapatalk
1 - 4 of 4 Posts
Something in the ignition switch possibly?
Check the pickup coil resistance. I have seen those bad right from new, especially those ebay specials. I have also seen them wired backwards.

The resistance should be 420-600 ohms. If the resistance levels are within tolerance, swap the wires.
  • Like
Reactions: 1
Check the pickup coil resistance. I have seen those bad right from new, especially those ebay specials. I have also seen them wired backwards.

The resistance should be 420-600 ohms. If the resistance levels are within tolerance, swap the wires.
Thanks I will give that a try this morning If it works I will owe you big time.

Sent from my SM-G530W using Tapatalk
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top