Hi,
I have a 2003 Grizzly 660 that is having some starting problems. I've been advised to change the spark plug, so after much looking around, I finally found it where it seemed like it would be impossible to turn a wrench. It is very tight, reaching over the wheel. Is there a trick to this? I took the right panel off (Panel A), as the owner's manual said. If I could turn the plug, I still wouldn't be able to see what I'm doing. It's rather frustrating... It has to be mentioned that I have no Grizzly repair experience
Thanks in advance for any help or tips (if there are any).
HL
I have a 2003 Grizzly 660 that is having some starting problems. I've been advised to change the spark plug, so after much looking around, I finally found it where it seemed like it would be impossible to turn a wrench. It is very tight, reaching over the wheel. Is there a trick to this? I took the right panel off (Panel A), as the owner's manual said. If I could turn the plug, I still wouldn't be able to see what I'm doing. It's rather frustrating... It has to be mentioned that I have no Grizzly repair experience
Thanks in advance for any help or tips (if there are any).
HL
