Yamaha Grizzly ATV Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi, In the last day my 2012 Rhino when decending in Low is not holding. It wants to free-roll, then a grinding noise comes in followed by a clunk . After the clunk the decent control has a hold as it should. Any thoughts as what this may involve?
 

·
Registered
Joined
·
5,545 Posts
Oneway bearing (aka: Sprag Clutch) is gone. Replace it with a OEM Yamaha bearing ONLY. All other bearings will have troubles.....this is a well proven fact.

Replacement:
- drain engine oil
- remove drivers side seat
- remove clutch cover
- remove primary clutch, including inner sheave.
- remove engine side cover located behind the primary clutch inner sheave. The oneway bearing is right there.

When installing the new bearing, make sure it's installed in the correct direction.
 
  • Like
Reactions: Schirm
1 - 2 of 2 Posts
Top