Yamaha Grizzly ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Replaced the throttle position sensor and it ran great, but from what I've seen the code should run around 17 for this and I was reading at 122. After I tried to adjust, it will no longer start without ether. Once it starts and runs, it will not restart. Diagnostics shows code 22 in D61, which I believe is an air temp sensor. Does anyone have any ideas on this? Supposed to got to Hatfield McCoy again Dec 3rd, so any help is greatly appreciated!
 

·
Premium Member
Joined
·
8,892 Posts
17 is when the throttle is closed. 122 is WOT however 122 is out of range.
As for the 22 code check that the plug is intact with no bent pins and fully seated. This sensor is very fragile did you touch it or rough it up?
 
1 - 2 of 2 Posts
Top