Yamaha Grizzly ATV Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
I'm replacing the front wheel bearings and got the ball joints off with an impact. They're supposed to be torqued to 18 foot pounds. But they spin. Any help is greatly appreciated.
 

·
Registered
2012 grizzly 700 eps
Joined
·
454 Posts
Make sure the threads are clean. If that doesn't work try vice grips to clamp the 2 peices together.
 

·
Premium Member
Joined
·
9,514 Posts
Sometimes all that is need is to lower the a-arm down on to a block of wood or a jack stand to put enough pressure on the ball joints to tighten them up.
 
1 - 4 of 4 Posts
Top