Yamaha Grizzly ATV Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
370 Posts
Discussion Starter #1
I'm in the process of installing new transmission bearings in the cases. I'm not the one who removed the bearings so there's one bearing that I'm not sure about. It's the only bearing that is sealed on one side. I'm assuming that it goes in with the sealed part against the case. Is that right?
 

·
Premium Member
Joined
·
7,910 Posts
This a question for dezz..
Is that the bearing for the drive axle?
Is the hole in the center part of the oil galleries?
If yes my guess would be that the seal goes toward the inside away from the case.
 

·
Registered
Joined
·
370 Posts
Discussion Starter #3
This a question for dezz..
Is that the bearing for the drive axle?
Is the hole in the center part of the oil galleries?
If yes my guess would be that the seal goes toward the inside away from the case.
Yes, it's the drive axle bearing. The hole in the center of where the bearing goes is for the oil delivery pipe.
 
  • Like
Reactions: danngerous667

·
Registered
Joined
·
370 Posts
Discussion Starter #4
I should have asked this question in my Bearing installation thread. I'll re ask it there.
 
  • Like
Reactions: danngerous667

·
Registered
Joined
·
370 Posts
Discussion Starter #5
The bearing goes in with the seal against the case. Thank you @dezz for confirming this. You're always of great help and advice.
 
1 - 5 of 5 Posts
Top