Won’t shift

1266 Views 4 Replies 3 Participants Last post by Ridgway81432, Nov 13, 2017

Ghayes1990

Discussion Starter · Nov 12, 2017

I was using my 03 to push around some leaves and when I went to back up it did nothing. It’s stuck in high gear. The shifter will move but the tranny does nothing. I took off the little control module on the side of the motor and cleaned the contacts but still nothing. Any help would be greatly appreciated.

Save

1 - 5 of 5 Posts

dezz

· #2 · Nov 12, 2017 (Edited)

03 what?
If you have a signature, many can't see it.

Your linkage could have let go from the transmission, or the shifter itself. On my Grizzly 660, I have had the bolt that holds the linkage in the transmission come out.

Save

Reactions: 1

Ghayes1990

Discussion Starter · #3 · Nov 12, 2017

03 grizzly 660. It looks like it may have come off the transmission. I thought I checked it but I guess I should have looked a little closer. Thanks so much

Save

dezz

· #4 · Nov 12, 2017

Ghayes1990 said:
03 grizzly 660. It looks like it may have come off the transmission. I thought I checked it but I guess I should have looked a little closer. Thanks so much

Make sure you line up the lever on the transmission correctly before tightening the bolt. Remove the bolt completely and you'll see what I mean.

Save

Ridgway81432

· #5 · Nov 13, 2017

Welcome from Colorado.
You came to the right place for help.
Stick around, we like pictures.

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month