Yamaha Grizzly ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
2008 Grizzly 700 will not start in gear and no brake light when foot lever and left hand rear brake lever applied. Seeking solutions...please help
 

·
Registered
Joined
·
5,537 Posts
Check the switch on the left handlebar perch. It's held in with a metal clip. Those can get sticky sometimes and will not extend when you pull the handle.
 
  • Like
Reactions: dnglbre

·
Grand High Inquisitioner
Joined
·
990 Posts
Check the switch on the left handlebar perch. It's held in with a metal clip. Those can get sticky sometimes and will not extend when you pull the handle.
+1. I had one of these fail once. It was like $20 to replace. You can test it by pulling the connectors off and jumping them with a paper clip or something.
 

Attachments

·
Premium Member
Joined
·
7,910 Posts
Check the "signal system" fuse. Won't start in gear if tail light fuse is blown. If it blows again you'll need to find the cause.
 
1 - 6 of 6 Posts
Top